What are the methods for some routine parameter measurements with a spectrum analyzer? The application of spectrum analyzers in fiber optic communication products, using the AQ6370 Spectrum Analyzer as an example, details the methods for making some routine parameter measurements using a spectrum analyzer. These parameters include the bandwidth of the spectrum, side mode rejection ratio, gain, noise figure and system OSNR. The article also mentions some of the basic features of the spectrum analyzer, such as the screen display of measurement conditions, marker values and other data, and how to perform measurements of specific parameters through different menus. This article emphasizes the importance of proficiency in the use of spectrum analyzers and encourages sharing and communication to promote the development and application of the technology.

Translated with DeepL.com (free version)

With the rapid advancement of 5G networks, optical communication technology has ushered in unprecedented changes. Dense wavelength division multiplexing (DWDM) systems have become the core of modern fiber optic communication networks due to their efficient data transmission capability and spectrum utilization. However, the dense channel distribution and high-speed data transmission in DWDM systems place higher requirements on the optical spectrum analyzer (OSA).

On the basis of mature DWDM, EDFA and other technologies, ultra-high-speed optical communications require a fuller use of the optical spectrum bandwidth and carrier information, based on the existing fiber optic networks, equipment, technology provided by the transmission channel to multiply the expansion of data traffic.

Capable of measuring in the visible to near-infrared wavelength bands from 350 nm to 1200 nm, the 6362C Spectrum Analyzer meets the growing demand for medical, biological and materials processing applications. 6362C Spectrum Analyzer offers high wavelength resolution and a wide dynamic range for clear characterization of spectral details and fine reproduction of spectral signatures.

The BERTWave MP2110A all-in-one instrument is used in multi-channel module evaluation, TOSA/ROSA evaluation, and active optical cable (AOC) and direct-attached cable (DAC) evaluation. The instrument is capable of performing Tx/Rx signal wavemask margin testing, Rx signal eye diagram analysis (including jitter, Tr/Tf, etc.), Tx signal eye diagram analysis (including jitter, Tr/Tf, extinction ratio, etc.), and Rx signal receive sensitivity testing (BER measurement).

Operating instructions for the ANRITSU MP2110A test equipment cover detailed steps for connection, setup, calibration, and TDECQ measurements. This document covers the key features of the MP2110A, such as its clock recovery function and test capabilities for use with various high-speed communication standards.The MP2110A's procedure for performing TDECQ tests through physical connection, software setup, and calibration.

SR, LR, LRM, ER and ZR are the more common module types in the 10GIEEE standard, but what is the difference between 10g SR, LR, LRM, ER and ZR? First we need to know what they represent. In fiber optic communication, SR, LR, LRM, ER and ZR are a kind of distance terminology in 10G optical module transmission, SR means short distance, LR means long distance, LRM means length extended multipoint mode, ER means ultra-long distance, and ZR means the longest distance.